Led running controller v.1.0

Controller “Running turn” on 9 channels.

Characteristics:
– 9 channels;
– management by minus;
– maximum current per 1 channel – 1A;
– fill speed setting;
– board size – 35x45mm;
– at the output without stabilizer.

Setup
To configure the controller you need to do the following::
– press and hold the “SET” button
– at the entrance “+” file permanent “+” (not from the turn signal relay).
After 2 seconds the controller will enter setup mode. In this case, channel 1 will start flashing, Total 15 blinking. Each blink increases the delay between channels by 5ms, i.e. the maximum delay will be 75ms. To change the setting, release the SET button after the desired flash.
– submit “+” from the turn signal relay and make sure, that in one cycle all channels manage to work.

Restore the supply diagram “+” from the car turn signal relay.