Ford Escape S and SE Fog Light Controller

This device will be useful for Ford Escape S configurations in which the PTF control power unit (both back and front) missing.
In addition to the missing wiring in the bumper to the bulbs, no fuse yet, pins on connector, and most likely more relays and transistors in the BCM.

Replacing the BCM with another one leads to its firmware and prescribing your keys, so we offer an alternative solution, which will be much cheaper and easier to install.

The controller connects to the CAN bus MS-CAN and analyzes data packets, turning on the lamps at the right time. The power element for controlling fog lamps are powerful transistors and relays.

In version 1.1 in the logic of the device, the function of "bend" PTF has been added, when, when the low beam is on and the steering wheel is turned at a certain angle, the corresponding front PTF lamp lights up, and when reverse gear is engaged, the signal is inverted. When the steering wheel is returned to the zero position, the time delay lamp fades out smoothly. The work of the "turning" PTF is blocked at a vehicle speed of more than 30 km / h.

Version 1.2 allows additional control of DRL lamps. In normal mode, DRLs turn on immediately when the ignition is turned on., and if these lamps are connected to our block, then DRLs will only turn on when the automatic transmission selector is in the DRIVE position.

Version 1.3 (не доступна) allows you to additionally control the electric interior heater (PTC). cm. video.

The installation process is detailed in the link. https://driver.top/exp/30553

Also watch video https://youtu.be/v1xMs1_zGF8

On all devices sold before 01.11.2021 of the year, found a bug in the firmware, which is manifested by the blinking of the front fog in the cornering lights mode at a speed greater than 30 km/h. Check, if so prisylajte correct